FuriousFPV Mini RX for Frsky

$ 22.95

The Furious Mini RX for Frsky is designed for micro quads such as Toretto 130.

FEATURES

1. Mini size: 17x24 mm.
2. Light Weight: 2.5g (with antenna).
3. Operating Range: 500m.
4. S-bus output without inverted (don't need inverted on FC).
5. 8 channel output. 
6. Telemetry HUB.
7. Input voltage: 4-6V (normal 5V).
8. Compatibility: FrSky Taranis, Taranis Plus, & XJT module

NOTE: Regarding F3 chip, you need go to CLI on cleanflight and
set sbus_inversion = OFF
save

Configuration

Following, there’s some useful info for the setup and use of your Furious Mini RX.

1. Binding the receiver to the Frsky Taranis

  • In the Taranis, go to MODE SETUP (page 2) in the model configuration.
  • Go to Mode inside Internal RF and select D8.
  • Press and hold the receiver bind button and plug your battery in to turn the receiver on.
  • Release the button. A green LED lights up in the receiver.
  • Going back to the Taranis; we press BIND. The transmitter beeps, indicating it’s in bind mode.
  • Wait for the green LED on the receiver to turn off. The binding procedure has finished.
  • Exit the BIND mode in the Taranis.
  • Unplug the battery to turn off the receiver.

2. Binding the receiver to the XJT module

  • Using the dip switches of the XJT module, select the D8 mode. They shoud be in the following position: switch 1 = ON, switch 2 = OFF.
  • Press and hold the receiver bind button and plug your battery in to turn the receiver on.
  • Release the button. A green LED lights up in the receiver.
  • Press and hold the bind button and turn the transmitter on.
  • Release the button. A green light shoud blink in the module, indicating it’s in bind mode.
  • Wait for the green LED on the receiver to turn off. The binding procedure has finished.
  • Turn the transmitter off.
  • Unplug the battery to turn off the receiver.

3. Receiver Configuration in the Cleanflight configurator

  • n the PORTS PORTS tab, select the UART that corresponds to the receiver (usually UART3 in F3 flight controllers) and activate Serial RX.
  • Save by clicking on the Save and Reboot button.
  • In the CONFIGURATION tab, in the Receiver Mode section, select RX_SERIAL.
  • In the same tab, in the Serial Receiver Provider section, select SBUS.
  • Save by clicking on the Save and Reboot button.
  • Go to CLI and type the following commands:
    set sbus_inversion = OFF
    save
    The FC will reboot, applying the change.
  • Go to the RECEIVER tab and make sure the receiver acts like it should.


4. Telemetry Configuration:

  • In the PORTSPORTS tab, select the UART that corresponds to the telemetry (usually UART2 in F3 flight controllers) and select FrSky inTelemetry. Leave the baudrate to AUTO.
  • Go to CLI, and type the following commands:
    set telemetry_inversion = OFF
    save
    The FC will reboot, applying the change.
  • Make sure you’re getting thetelemetry values in our Taranis correctly.